How do I do this? I'm looking to do this on Windows XP, but if none can be provided, instructions for other versions are acceptable, too (Server and Client SKUs, all variations, across versions as well). This information is written to the registry by the Network tool in Control Panel as part of the Setup process. Some of this information is also supplied by the Dynamic Host Configuration Protocol (DHCP) Client service if the DHCP Client service is enable.. Read More. For information about how to edit the registry, view the .
Note that you should back up the registry before you edit it. If you are running Windows NT or Windows 2. Emergency Repair Disk (ERD). To change these parameters, use the following procedure: Start Registry Editor (Regedit. The relationship between an Adapter ID and Network Connection can be determined by examining HKEY.
The Name value in these keys provides the friendly name for a network connection used in the Network Connections folder. Values under the latter keys are specific to each adapter. Parameters for which there may be both a DHCP and statically configured value may or may not exist, depending on whether the system/adapter is DHCP configured and whether static override values have been specified. A restart of the system is required for a change in any of these parameters to take effect.. This is the Key you are looking for I Believe: > IGMPLevel. Key: Tcpip\Parameters. Value Type: REG. At level 0, the system provides no multicast support.
Disable and Remove Unwanted Services on RHEL/CentOS 7 Minimal Installation by Matei Cezar During the preparation to install or upgrade to the Cisco VPN Client 3.5.X for Windows on Microsoft Windows XP. IPSec is also found under Services. Control Panel In order to disable ICS through the Control Panel, use these steps.
At. level 1, the system can only send IP multicast packets. At level 2. the system can send IP multicast packets and fully participate in IGMP. You should set the registry key to 0 to have no multicast support. You can re- install or reset.
But with the Net. Shell utility, you can reset the TCP/IP stack to restore it to its state that existed when the operating system was installed. So our application does not need Windows TCP/IP Stack and We Want to uninstall it the moment our application starts. Please help. Thanks in Advance. The TCP/IP stack is an essential part of any modern OS, including recent versions of MS Windows.
As explained on MS knowlegebase Q2. Win XP): Because TCP/IP is a core component of Windows, you cannot remove it. At any rate, even if it were possible, no program that uses TCP/IP (which is most modern softtware, since most contain some kind of net integration, auto update etc.) would work, and most would probably fail in mysterious ways, since no one tested that configuration. So the short answer is: Don't do it. Maybe you could explain why you feel it necessary to remove TCP/IP networking? Then we might be able to help you.
Edit: Based on your comment below, if you want bypass/disable the ARP handling of the TCP/IP stack, then Win. Pcap should let you do that. If not, you probably need to write your own Windows network driver.
Again, this seems extremely complicated and intrusive. Could you please describe what your application does and why you even need to mess around with low- level networking?
Seems futile my friend if their is an answer to your question it is no, you cant.